Forum

obermeier
@obermeier
Registered
Honorable Member
Joined: Oct 8, 2012
Topics: 22 / Replies: 573
Reply
Rhode Island Wiring

I used YNZ's harness in a '48 C8 Cp,. and it was absolutely spot on. Only difference between the 8 and 6 is the length of the wire for the distribut...

3 years ago
Forum
Reply
Emergency brake doesn’t hold after a drive, holds after car cools off

YOU also need to jack up all four wheels and wedge the brake pedal down and check that all four wheels are actuated the same. degree. Also check the ...

4 years ago
Forum
Reply
Hudson 262 CI Engine ---Vacuum at Idle?

Yes, it should be 17-19 normally. Did this just happen or has it been like that all along?

4 years ago
Forum
Reply
Generator troubleshooting

They will be marked (stamped into the body near the terminals). The larger post is A.

4 years ago
Forum
Reply
Generator troubleshooting

No, they work either way, but the voltage coil points are of different material to minimize arcing and metal transfer. If you have them the wrong ...

4 years ago
Forum
Reply
Generator troubleshooting

No, a generator will not reverse polarity by disconnecting the battery. You need to get that voltage reading of 7,2

4 years ago
Forum
Reply
Generator troubleshooting

They are not interchangeable, but will work for a while until the voltage coil points burn out. Usually stamped into the base plate.

4 years ago
Forum
Reply
Generator troubleshooting

I doubt it, as the generator is grounded through the mounting. You do need to check the regulator voltage setting though.

4 years ago
Forum
Page 3 / 40