use the one you have. the 6 volt one. Go to a local parts store and get a resistor for a late 50s or early 6os Chev. or Morpar. cut the feed wire to ...
The lock pin is about 1/8in square, should be a cam on the tumbler barrel to push it into the side of the holder to lock it. a spring to push it down ...
do not force it, 50% chance you will break it! when locked, a small pin locks the t-handle and holder together. When unlocked it turns. I can not reme...
I have read about a new kind of float valve that uses a steel ball instead of a needle that is not suppose to stick. I have not used one, so can not s...
It sounds like you may have 2 problems with your carb.#1 float needle sticking in its seat . If it has the rubber like tip, sometimes the new type fue...
I would check the gas tank for something getting into position to block the fuel pickup tube, or the fuel pickup tube bent out of proper position. ...
remove the center divider, remove the INSIDE windshield metal molding, remove the glass from the INSIDE (it just lifts out) the stainless is just a th...
also check the hinge pins and the holes thay turn in for ware.if thay are loose it can keep the door from staying adjusted and make them rattle.
If it is not the ground I have had the spring that holds the inslater that presses the contacts against the bulb contacts on the end of the bulbs ...
If it was me ,1 I would drop the oil pan.Then check the oil filter and pick up to make sure it is not sucking air.remove the valve body and clean it a...
nope not 46-47 thay have the nobs that stick through the dash with nuts to help hold the radio.