That is good to use. Just make sure you put the nut flush with the top of the steering shaft and a flat piece of metal so as not to damage the shaft ...
Put DANA CORP in your computer and you will see that you can order a complete set of 2.73 gears from them. That is where I got mine. Walt.
You are sending hot water into the wrong side of the rancho valve. Walt.
The water is controlled by the rancho valve. My way to have the hoses is the only way you can not get heat with rancho valve closed. I can drive my ...
Just as Eddie said, your Ranco Valve is not closing. When Ranco Valve is closed there can not be any back flow. Your hoses should be hooked up as f...
The 112 hood opens from the front, won't work on a 39 Hudson. Walt.
Lee, Walt here, how did the car drive back home from San Simeon? Did you do the carbs back home with the Uni-Syn? Walt.
Make sure it's a wide block. The horse power depends on how much you want to spend. Money talks. Walt.
Just use today's oil, 10-40 syn-tec and no bearing problems. My Hornet has 144,000 miles since rebuild and has been driven cross country 17 times at ...
Be careful on which gear ration you choose. Your engine is a 232 CID and if ratio is below 3.0 you will be in second gear most of the time. 232 has ...
Find a 308 rear and it will go right in as all 48 to 54 have narrow rears and the drive shaft are all the same. What transmission is in your car? St...
Hudson's do not run enough oil pressure to keep them oiled. That is the reason when 1956's came with them we had to change them back to solid lifters...