No way can you pull the impeller back out. Don't try it as you will not be able to return it. Make sure you tell them the Hudson factory setting lik...
Yes, the same applies to the 8 cylinder water pump. Walt.
With the impeller that low you will have heating problems. Hudson set the impeller so that it was 3 to 6 thousands of an inch clearing the back plate...
You have a motor plate fro a 48 to 50 262 engine. the pointer started in 1951. Walt.
Oil will not go into the head until you remove the small brass cup that is in the hole. Speedo must be removed to remove the brass cup. Then put 3 d...
Where you have the red line is the motor pointer. Put a dab of white paint on the very end. Then paint the long mark on the flywheel and line it up...
Is your engine the narrow block, 48 to 50 or the wide block 51 to54? Walt.
Early Hudson 8's had no vacuum port, so you have a WDO 8 cylinder carb on your 262 engine, Will not work. If you have the narrow block, 48 to 50 you...
Vacuum in a new rebuilt Hornet engine is between 17 and 20 inches. Walt.
Turn plug in till it stops, then turn out 1/2 turn and grease it good and every 1,000 miles. if not it will wear a flat spot and no adjustment will h...
Those that go bigger than 215 are asking for trouble. Get a flat in the rain and try to install the spare if the same size. Do not install a smaller...