Forum

The 311s is for 35 Terraplanes model G and all commercial 6 models which are hand chokes. The model GU 6 1935 take model 309s which is an automatic W...

You seem to forget, you are running the pump on direct drive. Try the system when it is being run by the engine. It's run by the camshaft and is not...

All splasher engines have about 3 to 6 pounds oil pressure. The oil pump sends oil to the front then the rear with each cycle. Not enough for a mode...

You may have to grease it a few times and hit a few bumps to get the squeak gone. This will move the grease all around the bolt and bushing. Walt.

With the 2.73 rear you can cruise at 95 at about 3,200 RPM's. 2,000 RPM's is 60. Just returned from Crater Lake in Oregon and CA route 5 to Oregon 79...

Before you get ready to start your engine, make sure the upper tray is full of oil, and you have the oil pump primed. When I do a splasher and the en...

Use a good grade of 10-30 syn- tec oil. This is not the old days. Change oil by mileage, 1,000 miles or at least twice a year if yo do not drive it ...

Walt here; Remove the fitting and push a straight piece of wire into the fitting and work it back and forth. This should break up the dried grease. ...

Walt here; Make sure it's positive ground if it's still 6 volts. Negative if 12 volts.

Walt here. I only use cooper tires and did a lot of cross country driving, coast to coast. 3/4 inch whites. I was burnt with cokers. Not good for ...

1948 to some 1950's had the solenoid on the starter, all after had the solenoid on the left inner fender panel. Walt.

Your starter solenoid was stuck on. Replace it. Walt.