Forum

Unbolt the bell housing from the motor and slid to the rear and you can unbolt the torque converter from the flywheel. Walt.

Dirty points. Run a nail file between the points. Walt.

The 54 unit is not power steering, It's power assist. Walt.

If 55 or 56, all part numbers start with a 5. Yours is not 55 or 56. 55 and 56 has to be used with the 55 or 56 exhaust manifold. Walt.

Doug, did you make sure the leading edge of the seal faces the engine? When I rebuilt my engine in 1994 I used the Chrysler seal from Dodges, cut off...

Check the oil pressure switch. It's under the manifold between the 2 valve covers. Walt.

If they are new old stock they are junk. Dried out. Norm has new stock. Walt

Walt here; 2013 to 2015 is the latest so far. It has your phone listed as 407-259-3229.

Contact Norm Blackmer in the C I C chapter, he has the seals. Phone 1-909-984-5544 Walt.

If you are talking about the heat shield that is on the outer inner edge of the drum, just knock it off. It's pressed on. Walt.

No way. Walt

It also could be the front spring, as maybe the rubber pad that fits the top of the spring to keep metal to metal contact is worn through, and there i...

Do not stretch it while installing it in channel, be very careful going around the corners, now when you come to the end where each meet, which should...