Forum

KevinJets
@kevinjets
Registered
Reputable Member
Joined: Aug 4, 2015
Topics: 3 / Replies: 355
Reply
bore size for 308

Do not go over .060 overbore if you intend to drive just highways. That gives you a total of 317 CID, and no heating problems. That is what my engin...

11 years ago
Forum
Reply
What Coolant

Use Prestone. Stay away from modern anti-freeze. Walt.

11 years ago
Forum
Reply
carburetor

You need a Carter #749s WA-1 to have the correct fuel setting. That AMC carb will be to rich for your Wasp. Walt.

11 years ago
Forum
Reply
Correct water temperature

Jerry stated it correctly. You should be running at the half way mark, but going up hills it may climb a little higher. Walt.

11 years ago
Forum
Reply
52 engine on run stand

The best part is you have a few Walt's parts on your engine, now install on your car when engine is in, Walts gas return system and you will never get...

11 years ago
Forum
Reply
308 oil pressure

Hudson stated 35 lbs at 35 miles per hour and 20 lbs at idle. Stay away from high pressure. My engine has 143,000 miles since rebuild, with 17 trips...

11 years ago
Forum
Reply
choke has to be pulled to run right

1936 Terraplane model 62 takes a W-1 #329s, automagic choke. The 1936 model 61 takes 331s hand choke model. Which do you need? Contact me at xxxwal...

11 years ago
Forum
Reply
choke has to be pulled to run right

If you need it give me a few days. Walt.

11 years ago
Forum
Reply
choke has to be pulled to run right

Stay away from an original kit as they will not work with today's gas. I can get you a modern kit but it will take a few days. Just make sure you get...

11 years ago
Forum
Reply
choke has to be pulled to run right

I just have all the original Carter tools but no sets to sell. Manual, Carter, says when will not idle remove idle jet and clean, but do not use a je...

11 years ago
Forum
Reply
Draining the block

If it's a 51 to 54 block, the drain is above the starter and cover the starter before you remove the drain plug. If it's a 55 or 56 block, the drain ...

11 years ago
Forum
Reply
choke has to be pulled to run right

That stye carb was used from 1932 to 1936, both 6 and 8's. It takes special tools to remove all the jets, which I have, as using screw drivers jams t...

11 years ago
Forum
Reply
NEW 1.125" ANTI-SWAY BAR VS. ORIGINAL BAR

Can the welded plates on the lower trays handle the extra support? Walt.

11 years ago
Forum
Page 10 / 24