Forum

AdamB
@adamb
Registered
Reputable Member
Joined: May 15, 2014
Topics: 9 / Replies: 311
Reply
Dom's 47' Project

Starter can have the field coils swapped out so it is not as violent on 12V. If you have it rebuilt as 6V and run it on 12V, the starter pinion and ri...

4 years ago
Forum
Reply
'54 Hollywood Back Bench Seat ---Is it Unique?

Robert, the front lower edge of the rear seat bottom touches the carpet. No other filler parts that I know of.

4 years ago
Forum
Reply
'54 Hollywood Back Bench Seat ---Is it Unique?

Robert, the rear seats on the Coupes and Hollywoods sit about 5-6" forward of that raised seat platform. You are probably missing the two L shaped met...

4 years ago
Forum
Reply
50 pacemaker rear axle seals

[img]data:image/png;base64,iVBORw0KGgoAAAANSUhEUgAAAcQAAAC0CAYAAAAKClxqAAAgAElEQVR4Xu1dv48duZHm5A4cOLAN2HAgYA3vQDNr4IALHDgXzhpA2QizB9xG9w/o+aKBIns2cXi...

4 years ago
Forum
Reply
What color finish is Hornet engine bay?

I used Duplicolor ceramic engine paint, semi gloss black.

4 years ago
Forum
Reply
Starter removal 50 C6

Leave the short wire disconnected, but tape the ring terminal so it cannot short to anything. Most of these Supermatic and Drive Master setups were di...

4 years ago
Forum
Reply
Starter removal 50 C6

As to where the extra terminal on the wire from the "-" terminal of the coil goes to, sounds like it may be to the Kickdown switch if the car has Supe...

4 years ago
Forum
Reply
Overheating problem

First off, 190 degrees it not exactly overheating, especially of the outside are temps are higher. I have no idea where the car is located, so do not ...

4 years ago
Forum
Reply
Wire and connectors

YnZ's Yesterday Parts will have what you need. Brillman's double connector price is almost double YnZ''s !

4 years ago
Forum
Reply
Starter removal 50 C6

The starter is centered in the hole in the rear support plate by a machined boss on the rear end plate, not the studs. If the starter end-plate, or th...

4 years ago
Forum
Reply
Starter removal 50 C6

[quote="Dany Spring post=29430 userid=9982"]Those starter studs have a head in the center that is captured in a counterbore of the bell housing. The o...

4 years ago
Forum
Reply
Starter removal 50 C6

Ken Warner at Classic Generator can rebuild it. he converted Jeremy Larson's MCL-6006 to 12 volts and it works great. New armature, new 12V field coil...

4 years ago
Forum
Reply
Starter bolt removal

You do NOT remove the snap ring.....all that snap ring does is hold the big thick washer and the spring ahead of it on. What you DO, is push hard on t...

4 years ago
Forum
Reply
Help! 1934 Hudson Transmission won’t go into 2nd or 3rd!

OK, I am hearing impaired , and with the music in the video, I couldn't really hear the noise you are referring to.However, I can tell you that for 1s...

4 years ago
Forum
Reply
Help! 1934 Hudson Transmission won’t go into 2nd or 3rd!

I am in Plano TX about 330 miles NE of you. Maybe if you can get it transported here, in about a month, I could look at it. Have access to a lift. H...

4 years ago
Forum
Page 4 / 22