Notifications
Clear all
Topic starter
I purchased a new lock cylinder for trunk of my 51 Club Coupe. I am faced with a screw in the mounting hole that just spins but won't back out, The Body Service Manual says just center punch the screw and drill a 1/16" hole to remove it and expose the underlying allen set screw. But what I see is the screw is spinning on the inside as well. I don't think the right piece of hardware is in there. Anyone faced this problem?
Again many thanks,
YIH, Dean
Posted : 15/12/2014 8:07 am
Moved to "Hudson" category.
Posted : 15/12/2014 9:39 am
Leave a reply
